Toyota Tundra 2005 Service - Repair - Maintenance page 2552

Hide thumbs Also See for Tundra 2005:

Table of Contents

Boiling Water

SUSPENSION AND AXLE

Be careful not to drop the side gear and check the pinion and

side gear alignment.

While holding one of the side gears, measure the rotation

torque of the other gear.

Using SST and a press, install the 2 side bearings into the differ-

ential case.

Align the matchmarks on the ring gear and differential case.

REAR DIFFERENTIAL CARRIER (w/ LSD)

Tighten the 8 bolts uniformly, a little at a time.

Torque: 47 N·m (480 kgf·cm, 35 ft·lbf)

MEASURE ROTATION TORQUE OF DIFFERENTIAL

Rotation torque (standard):

27.5 − 43.0 N·m (281 − 439 kgf·cm, 20 − 32 ft·lbf)

INSTALL SIDE BEARINGS

09950−60010 (09951−00480, 09951−00640)

09950−70010 (09951−07150)

INSTALL RING GEAR ON DIFFERENTIAL CASE

Clean the contact surfaces of the differential case and

Heat the ring gear to about 100°C (212°F) in boiling wa-

Carefully take the ring gear out of the boiling water.

After the moisture on the ring gear has completely evapo-

rated, quickly install the ring gear to the differential case.

After the ring gear has cooled sufficiently, torque the set

bolts to which thread lock has been applied.

Thread lock:

Part No. 08833−00100, THREE BOND 1360K or equiv-

Torque: 125 N·m (1,270 kgf·cm, 92 ft·lbf)