Toyota Tundra 2005 Service - Repair - Maintenance page 2547

Hide thumbs Also See for Tundra 2005:

Table of Contents

SUSPENSION AND AXLE

Install the new thrust washer (Mark N) instead of the thrust

washers (Mark A − M) to the differential case side.

REAR DIFFERENTIAL CARRIER (w/ LSD)

When reusing the side gear, thrust washers and clutch

plates, skip the STEP 1.

Using a shop rag, clean off any foreign object from the

Apply all of the sliding and rotating surfaces with LSD oil.

SELECT ADJUSTING SHIM(S)

Measure the differential case dimension "A1", as shown

in the illustration.

Install the thrust washers (face their fine side to the side

gear) and clutch plates on the side gear.

Using SST to press down the thrust washers and clutch

plates with about pressure of 10 kgf (22 lbf), measure di-

mension "B1", as shown in the illustration.

Referring to the following selection table on the next

page, select the proper adjusting shim(s).

Adjusting shim thickness =

A1 − B1 − 16.175 mm (0.63681 in.)