Toyota Tundra 2005 Service - Repair - Maintenance page 3225

Double Cab:
Claw
2 Clips
BODY
REMOVAL
Negative
B a t t e r y
HINT:
Terminal
A bolt without a torque specification is shown in the standard
bolt chart (see page
1.
Disconnect the cable from the negative (-) battery terminal.
NOTICE:
BO4111
If the cable is disconnected from the negative battery termi-
nal, the preset AM and FM stations stored in the memory
will be erased. Be sure to make note of them before discon-
necting the cable.
CAUTION:
Work must not be started until at least 90 seconds after the
ignition switch is turned to the LOCK position and the cable
is disconnected from the negative (-) battery terminal.
(The SRS is equipped with a back-up power source. If work
is started within 90 seconds of disconnecting the cable
from the negative (-) battery terminal, the SRS may deploy.)
2.
(a)
(b)
(c)
(d)
H24383
3.
(a)
(b)
4.
Double cab:
(a)
(b)
5.
H16716
- INSTRUMENT PANEL
SS-2 ).
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
REMOVE FRONT DOOR SCUFF PLATE
Standard cab:
Remove the 5 screws and front door scuff plate.
Access cab (standard and wide body type):
Remove the 4 screws and front door scuff plate.
Double cab:
Remove the 4 screws and front door scuff plate.
Use the same procedures described above on the other
side.
Standard cab:
Access cab:
REMOVE COWL SIDE TRIM
Remove the 2 clips and cowl side trim.
Use the same procedures described above on the other
side.
Double cab:
REMOVE COWL SIDE TRIM BOARD
Remove the nut, 2 clips and cowl side trim board.
Use the same procedures described above on the other
side.
Double cab:
REMOVE SIDE PANEL
Author :
BO-1 11
BO4QF-04
Date :
4882