Toyota Tundra 2005 Service - Repair - Maintenance page 2673

®
Torx Screw
Airbag Connector
Correct
Matchmarks
BRAKE
STEERING ANGLE SENSOR
REMOVAL
1.
NOTICE:
If the airbag connector is disconnected with the ignition
switch in ACC or ON, DTCs will be recorded.
(a)
(b)
Screw Case
(c)
(d)
(e)
HINT:
Loosen the screw until the groove along the screw circumfer-
ence catches on the screw case.
F17124
(f)
(g)
CAUTION:
S
S
NOTICE:
When removing the steering wheel pad, take care not to
pull the airbag wire harness.
(h)
Wrong
F17125
2.
(a)
(b)
(c)
3.
SST
(a)
F06699
(b)
− STEERING ANGLE SENSOR
REMOVE STEERING WHEEL PAD
Disconnect battery negative terminal.
Place the front wheels facing straight ahead.
Remove the steering wheel lower No. 3 cover.
Remove the steering wheel lower No. 2 cover.
Using a torx® socket wrench (T30), loosen the 2 torx®
screws.
Pull out the wheel pad from the steering wheel.
Using a screwdriver, disconnect the airbag connector.
When storing the steering wheel pad, keep the upper
surface of the pad facing upward.
Never disassemble the steering wheel pad.
Disconnect the horn connector and remove the steering
wheel pad.
REMOVE STEERING WHEEL
Remove the steering wheel set nut.
Place matchmarks on the steering wheel and main shaft
assembly.
Using SST, remove the wheel.
SST 09950−50013 (09951−05010, 09952−05010,
09953−05020, 09954−05021)
REMOVE SPIRAL CABLE
Disconnect the 2 connectors.
Remove the 4 screws and remove the spiral cable.
BR−97
BR1YG−01