Toyota Tundra 2005 Service - Repair - Maintenance page 3001

BE-92
Warning Light
Ignition
Switch
Battery
BODY ELECTRICAL - COMBINATION METER
14. 1GR-FE (Standard cab):
INSPECT OIL PRESSURE SWITCH CONTINUITY
(a) Disconnect the connector from the switch.
(b) Check that continuity exists between the terminal and
ground with the engine stopped.
(c) Check that no continuity exists between the terminal and
ground with the engine running.
HINT:
The oil pressure should be over 24.5 kPa (0.25 kgf/cm
I01278
psi).
If the continuity is not as specified, replace the switch.
15. 1GR-FE (Access cab) and 2UZ-FE:
INSPECT OIL PRESSURE SENDER GAUGE CONTI-
NUITY
(a) Disconnect the connector from the sender gauge.
(b) Check that no continuity exists between the terminal and
ground with the engine stopped.
(c) Check that continuity exists between the terminal and
ground with the engine running.
HINT:
I26956
The oil pressure should be over 29.0 kPa (0.3 kgf/cm
If the continuity is not as specified, replace the seder gauge.
16. INSPECT BRAKE WARNING LIGHT
(a) Disconnect the connector from the brake fluid warning
switch.
(b) Release the parking brake pedal.
(c) Connect the terminals on the harness side of the level
warning switch connector.
(d) Start the engine, and check that the warning light lights
up.
If the warning light does not light up, inspect the bulb or wire har-
I01279
ness.
Author : Date :
2
, 3.55
2
, 4.2 psi).
4649