Toyota Tundra 2005 Service - Repair - Maintenance page 2764

SR-86
SST
SST
STEERING
Fulcrum Length
F06750
Brass Bar
R06400
W01261
3 mm
(0.12 in.)
or less
W04223
- POWER STEERING GEAR
(b) Using a spanner to hold the steering rack steady, and us-
ing SST, tighten the rack end.
SST 09922-10010
Torque: 76 N·m (770 kgf·cm, 56 ft·lbf)
NOTICE:
Use SST 09922-10010 in the direction shown in the illustra-
tion.
HINT:
Use a torque wrench with a fulcrum length of 345 mm (13.58
in.).
(c) Using a brass bar and hammer, stake the washer.
NOTICE:
Avoid any impact on the rack.
(d) Perform the same procedure on the other side.
17. INSTALL RH AND LH RACK BOOTS, CLAMPS AND
CLIPS
(a) Ensure that the steering rack hole is not clogged with
grease.
HINT:
If the hole is clogged, the pressure inside the boot will change
after it is assembled and the steering wheel is turned.
(b) Set a new clamp to the groove of the rack boot.
(c) Install the boot.
NOTICE:
Be careful not to damage or twist the boot.
(d) Using SST, tighten the clamp as shown in the illustration.
SST 09521-24010
(e) Install the clip to the rack boot.
(f) Perform the same procedure on the other side.
18. INSTALL RH AND LH TIE ROD ENDS AND LOCK NUTS
(a) Screw the lock nut and tie rod end onto the rack end until
the matchmarks are aligned.
(b) After adjusting toe-in, tighten the nut
(See page SA-5
Torque: 55 N·m (560 kgf·cm, 41 ft·lbf)
Author :
).
Date :
4412