Toyota Tundra 2005 Service - Repair - Maintenance page 3309

BODY - FRONT SEAT (Split Type: Passenger's Side)
REASSEMBLY
CAUTION:
Wear safety gloves, because the sharp edges and surfaces
of the seat frame may cause injury to the hands.
HINT:
A bolt without a torque specification is shown in the standard
bolt chart (see page
1. INSTALL RECLINING ADJUSTING CABLE
(a) Temporarily install the reclining adjusting cable.
(b) Tighten the adjusting nuts.
HINT:
When tighten the nuts, hold one and tighten the other.
(c) Connect the clamp.
2. INSTALL RH AND LH SEAT TRACK HANDLE SUB-AS-
SEMBLY
(a) Install the RH seat track handle sub-assembly with the
H24371
nut.
Torque: 10 N·m (102 kgf·cm, 7 ft·lbf)
HINT:
Apply MP grease to the sliding part of the seat track handle
sub-assembly .
(b) Perform the same procedure on the other side.
H24370
3. INSTALL SEAT TRACK ADJUSTING HANDLE
(a) Install the seat track adjusting handle.
(b) Using a screwdriver, engage the seat track cover spring.
HINT:
Tape the screwdriver tip before use.
(c) Perform the same procedure on the other side.
H24369
SS-2 ).
Author : Date :
BO-195
BO4SZ-02
4966