Toyota Tundra 2005 Service - Repair - Maintenance page 2803

RS-36
SUPPLEMENTAL RESTRAINT SYSTEM - FRONT PASSENGER AIRBAG ASSEMBLY
REMOVAL
NOTICE:
z
If the wiring connector of the SRS is disconnected
and the ignition switch is in the ON or ACC position,
DTCs will be recorded.
z
Never use airbag parts from another vehicle. When
replacing parts, replace them with new ones.
1. PRECAUTION (SEE PAGE
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
Wait for 90 seconds after disconnecting the cable to prevent the
airbag working.
3. REMOVE FRONT DOOR SCUFF PLATES
(SEE PAGE BO-1
4. Standard cab:
Access cab:
REMOVE COWL SIDE TRIMS (SEE PAGE
5. Double cab:
REMOVE COWL SIDE TRIM BOARDS
(SEE PAGE BO-1
6. Double cab:
REMOVE SIDE PANELS (SEE PAGE
7. REMOVE LOWER FINISH PANEL
(SEE PAGE BO-1
8. REMOVE GLOVE COMPARTMENT DOOR
(SEE PAGE BO-1
9. REMOVE LOWER NO. 2 FINISH PANEL
(SEE PAGE BO-1
10. Standard cab:
Access cab (w/o Large type console box):
Double cab (Split type seat):
REMOVE LOWER CENTER COVER
(SEE PAGE BO-1
11. Access cab (w/ Large type console box):
Double cab:
REMOVE SHIFTING HOLE COVER
(SEE PAGE BO-1
12. Access cab (w/ Large type console box):
Double cab:
REMOVE UPPER CONSOLE PANEL
(SEE PAGE BO-1
13. Access cab (w/ Large type console box):
Double cab:
REMOVE REAR CONSOLE BOX
(SEE PAGE BO-1
14. Access cab (w/ Large type console box):
Double cab:
REMOVE FRONT CONSOLE BOX
(SEE PAGE BO-1
Author :
RS-1 AND
11)
11)
BO-1
11)
11)
11)
11)
11)
11)
11)
11)
Date :
RS123-01
RS-3 )
BO-1 11)
11)
4451