Toyota Tundra 2005 Service - Repair - Maintenance page 2761

SST
Cylinder End
Stopper
SST
SST
Oil Seal
STEERING
5.
(a)
Wire
(b)
(c)
R11656
6.
(a)
(b)
(c)
If there is change in the vacuum, check the installation of the oil
seals.
F06757
7.
(a)
Vinyl Tape
(b)
(c)
NOTICE:
Be careful not to damage the teflon rings and oil seal.
F06758
8.
(a)
(b)
NOTICE:
Make sure to install the oil seal in the correct direction.
9.
(a)
F08339
(b)
(c)
- POWER STEERING GEAR
INSTALL CYLINDER END STOPPER
Align the installation hole for the wire of the stopper with
the slot of the rack housing.
Install a new wire into the stopper.
Using SST, turn the stopper clockwise 400° to 500°.
SST 09631-16010
AIR TIGHTNESS TEST
Install SST to the rack housing.
SST 09631-12071
Apply 53 kPa (400 mmHg, 15.75 in.Hg) of vacuum for
about 30 seconds.
Check that there is no change in the vacuum.
INSTALL CONTROL VALVE ASSEMBLY
To prevent oil seal lip damage, wind vinyl tape on the ser-
rated part of the valve shaft.
Coat the teflon rings with power steering fluid.
Install the valve assembly into the valve housing.
INSTALL OIL SEAL
Coat a new oil seal lip with power steering fluid.
Using SST, press in the oil seal.
SST 09612-2201 1
INSTALL CONTROL VALVE HOUSING WITH CON-
TROL VALVE ASSEMBLY
Place a new gasket on the rack housing.
Align the matchmark on the control valve housing with
control valve assembly and rack housing.
Install the 2 bolts.
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
Author :
SR-83
Date :
4409