Toyota Tundra 2005 Service - Repair - Maintenance page 3020

BODY ELECTRICAL
7.
(a)
(b)
1
(c)
2
I27172
(d)
(e)
(f)
1
2
If operation is not as specified, replace the motor.
I14318
8.
1
2
(a)
(b)
(c)
I21325
(d)
(e)
(f)
2 1 If operation is not as specified, replace the motor.
I21327
9.
2
(a)
(b)
1
(c)
I27174
- POWER WINDOW CONTROL SYSTEM (Double Cab)
Driver side door:
INSPECT POWER WINDOW MOTOR PTC THERM-
ISTOR OPERATION
Disconnect the connector from the motor.
Connect the positive (+) lead from the ammeter to termi-
nal 1 of the motor side connector and the negative (-) lead
to negative terminal of the battery.
Connect the positive (+) lead from the battery to terminal
2 of the motor side connector, and raise the window to the
fully closed position.
Continue to apply voltage and check that the current
changes from approximately 14 A to less than 1 A within
4 to 90 seconds.
Disconnect the leads from the terminals.
Approximately 90 seconds later, connect the positive (+)
lead from the battery to terminal 1 and the negative (-)
lead to terminal 2, then check that the window begins to
move down.
Passenger side door:
INSPECT POWER WINDOW MOTOR PTC THERM-
ISTOR OPERATION
Disconnect the connector from the motor.
Connect the positive (+) lead from the ammeter to termi-
nal 2 of the motor connector and the negative (-) lead to
negative terminal of the battery.
Connect the positive (+) lead from the battery to terminal
1 of the motor connector, and raise the window to the fully
closed position.
Continue to apply voltage and check that the current
changes from approximately 14 A to less than 1 A within
4 to 90 seconds.
Disconnect the leads from the terminals.
Approximately 90 seconds later, connect the positive (+)
lead from the battery to terminal 2 and the negative (-)
lead to terminal 1, then check that the window begins to
move down.
Rear left door:
INSPECT POWER WINDOW MOTOR PTC THERM-
ISTOR OPERATION
Disconnect the connector from the motor.
Connect the negative (+) lead from the ammeter to termi-
nal 1 of the motor connector and the negative (-) lead to
negative terminal of the battery.
Connect the positive (+) lead from the battery to terminal
2 of the motor connector, and raise the window to the fully
closed position.
Author :
BE-1 11
Date :
4668