Toyota Tundra 2005 Service - Repair - Maintenance page 2527

Hide thumbs Also See for Tundra 2005:

Table of Contents

Boiling Water

SUSPENSION AND AXLE

Align the matchmarks on the ring gear and differential case.

REAR DIFFERENTIAL CARRIER

Heat the ring gear to about 100°C (212°F) in boiling wa-

Carefully take the ring gear out of the boiling water.

After the moisture on the ring gear has completely evapo-

rated, quickly install the ring gear to the differential case.

After the ring gear has cooled sufficiently, torque the set

bolts to which thread lock has been applied.

Thread lock:

Part No. 08833−00100, THREE BOND 1360K or equiv-

Torque: 125 N·m (1,270 kgf·cm, 92 ft·lbf)

INSPECT RING GEAR RUNOUT

Install the differential case into the carrier and install the

plate washers to where there is no play in the bearing

(See step 8.).

Install the bearing cap (See step 11.).

Using a dial indicator, measure the runout of the ring gear.

Remove the bearing caps and differential case.

Maximum runout: 0.05 mm (0.0020 in.)

INSTALL DRIVE PINION BEARING OUTER RACES

AND ADJUSTING WASHER

Using SST and a press, install a new front bearing outer

race to the carrier.

09950−60020 (09951−00710),

09950−70010 (09951−07150)

Using SST and a press, install a new adjusting washer

and a new rear bearing outer race to the carrier.

09950−60020 (09951−00910),

09950−70010 (09951−07150)