Toyota Tundra 2005 Service - Repair - Maintenance page 2407

PR−14
PROPELLER SHAFT
SST
PR0034
− PROPELLER SHAFT ASSEMBLY (4WD)
(d) Install the spacer.
(e) Using SST to hold the flange, press in the bearing by tight-
ening with a new nut.
SST 09330−00021
Torque: 181 N·m (1,845 kgf·cm, 133 ft·lbf)
(f) Loosen the nut.
(g) Torque the nut again.
Torque: 82 N·m (835 kgf·cm, 60 ft·lbf)
(h) Using a hammer and punch, stake the nut.
3. Rear propeller shaft:
INSTALL PROPELLER SHAFT
(a) Align the matchmarks on the flanges and connect the
flanges with the 4 bolts, washers and nuts.
HINT:
If replacing either the center flange or intermediate shaft, reas-
sembly it so that the front side flange yoke of the intermediate
shaft and the rear side flange yoke of the propeller shaft are fac-
ing in the same direction.
(b) Torque the bolts.
Torque: 74 N·m (754 kgf·cm, 54 ft·lbf)