Toyota Tundra 2005 Service - Repair - Maintenance page 2454

SA−40
SUSPENSION AND AXLE
REMOVAL
1. DRAIN DIFFERENTIAL OIL
2. REMOVE DRIVE SHAFTS (See page SA−29)
3. DISCONNECT FRONT PROPELLER SHAFT
(See page PR−10)
HINT:
Support the front propeller shaft securely.
4. REMOVE TUBE WITH WIRE HARNESS ASSEMBLY
(a) Disconnect the breather hose, vacuum hose and actuator
connector.
(b) Remove the bolt and tube with wire harness assembly.
5. REMOVE FRONT DIFFERENTIAL CARRIER
(a) Support the front differential with a jack.
(b) Using a hexagon (12 mm) wrench, remove the rear
mounting nut.
(c) Remove the 2 front mounting bolts.
(d) Lower the jack and remove the front differential carrier.
6. REMOVE DIFFERENTIAL MOUNTING CUSHIONS
(a) Remove the 2 bolts and rear mounting cushion.
(b) Remove the 5 bolts and 2 front mounting cushions.
F06630
− FRONT DIFFERENTIAL CARRIER
SA09O−06