Toyota Tundra 2005 Service - Repair - Maintenance page 2823

RS-56
SUPPLEMENTAL RESTRAINT SYSTEM
Stripped Wire Harness Section
(d)
CAUTION:
z
z
H23934
(e)
Wire Harness
Diameter
HINT:
To calculate the area of the stripped wire harness section:
CAUTION:
If the wire harness is too thin or an alternative object is
AB0163
used to tie down the front passenger airbag assy, it may be
snapped by the shock when the airbag is deployed. Always
use a wire harness for vehicle use with an area of at least
1.25 mm
H17493
- SIDE AIRBAG ASSEMBLY (Power Adjuster Type)
Remove the 2 nuts and side airbag assembly from the
seatback assembly.
When removing the front seat airbag assembly, work
must be started 90 seconds after the ignition switch
is turned to the "LOCK" position and the negative (-)
terminal cable is disconnected from the battery.
When storing the front passenger airbag assembly,
keep the airbag deployment side facing upward.
Using a service-purpose wire harness for the vehicle, tie
down the front passenger airbag assembly to the tire.
Wire harness: Stripped wire harness section
2
1.25 mm or more (0.0019 in
Area = 3.14 x (Diameter)
2 2
(0.0019 in. ).
(1) Install the 2 nuts to the side airbag assembly.
Author :
2
. or more)
2
divided by 4
Date :
4471