Toyota Tundra 2005 Service - Repair - Maintenance page 2464

SA−50
SST
Front bearing
outer race
SST
SUSPENSION AND AXLE
SST
R13376
Rear bearing
outer race
R13281
R01197
SST
R11163
− FRONT DIFFERENTIAL CARRIER
(d) Using SST and a press, install the bearing outer race.
SST 09950−60020 (09951−00790),
09950−70010 (09951−07150)
7. INSTALL DRIVE PINION FRONT AND REAR BEARING
OUTER RACES
Using SST, install the 2 outer races.
SST 09570−22011
8. INSTALL DRIVE PINION FRONT BEARING
(a) Install the washer on the drive pinion.
HINT:
First fit a washer with the same thickness as the washer which
was removed, then after checking the tooth contact pattern, re-
place the washer with one of a different thickness if necessary.
(b) Using SST and a press, install the front bearing onto the
drive pinion.
SST 09506−30012
9. TEMPORARILY ADJUST DRIVE PINION PRELOAD
(a) Install the drive pinion, rear bearing and oil slinger.
HINT:
After adjusting the ring gear tooth contact pattern, assemble the
spacer and oil seal.
(b) Using SST, install the companion flange.
SST 09950−30012 (09951−03010, 09953−03010,
09954−03010, 09955−03030, 09956−03020)
(c) Coat the threads of the nut with hypoid gear oil.