Toyota Tundra 2005 Service - Repair - Maintenance page 3353

Claw
Clip
Claw
4 Clips
BODY - SEAT BELT PRETENSIONER
NOTICE:
When removing the retractor of the front seat outer belt,
take care not to pull the seat belt pretensioner wire har-
ness.
(1) Disconnect the pretensioner connector as shown in
the illustration.
(2) Remove the 2 bolts and retractor of the front seat
outer belt.
H11401
4. Double cab:
REMOVE FRONT SEAT OUTER BELT
(a) Remove the front door scuff plate.
(1) Remove the 4 screws, disengage the claw and front
door scuff plate.
(2) Remove the front door opening trim weatherstrip.
H24383
(b) Remove the rear door scuff plate.
(1) Remove the 3 screws.
(2) Using a screwdriver, disengage the clip and remove
the rear door scuff plate.
HINT:
Tape the screwdriver tip before use.
(c) Remove the rear door opening trim weatherstrip.
H16718
(d) Remove the lower center pillar garnish.
(1) Remove the front seat outer belt floor anchor.
(2) Using a screwdriver, remove the lower center pillar
garnish.
HINT:
Tape the screwdriver tip before use.
(e) Remove the front seat outer belt shoulder anchor.
H16719
Author : Date :
BO-239
5010