Toyota Tundra 2005 Service - Repair - Maintenance page 2472

SA−58
INSTALLATION
1. INSTALL DIFFERENTIAL MOUNTING CUSHIONS
(a) Install the 2 front mounting cushions with the 5 bolts.
Torque: 157 N·m (1,600 kgf·cm, 116 ft·lbf)
(b) Install the rear mounting cushion with the 2 bolts.
Torque: 108 N·m (1,100 kgf·cm, 80 ft·lbf)
2. INSTALL FRONT DIFFERENTIAL CARRIER
(a) Jack up the front differential.
(b) Install the 2 front mounting bolts.
Torque: 137 N·m (1,400 kgf·cm, 101 ft·lbf)
(c) Using a hexagon (12 mm) wrench, install the rear mounting nut.
Torque: 87 N·m (890 kgf·cm, 64 ft·lbf)
(d) Remove the jack.
3. INSTALL TUBE WITH WIRE HARNESS ASSEMBLY
(a) Install the tube with wire harness assembly with the bolt.
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)
(b) Connect the actuator connector, vacuum hose and breather hose.
4. CONNECT FRONT PROPELLER SHAFT (See page PR−15)
5. INSTALL DRIVE SHAFTS (See page SA−34)
6. FILL DIFFERENTIAL WITH HYPOID GEAR OIL (See page SA−36)
SUSPENSION AND AXLE − FRONT DIFFERENTIAL CARRIER
SA09S−05