Toyota Tundra 2005 Service - Repair - Maintenance page 3173

Protector
A
A
NOTICE:
When removing the moulding release sheet, be careful that
dirt or dust will not adhere to the face of the moulding.
NOTICE:
Do not apply excessive force onto the moulding, but steady
pressure with your thumbs.
4.
Install the front mudguard with the 4 screws.
5.
(a)
A - A
Protector
H20887
(b)
H20886
BODY - WHEEL OPENING MOULDING
(2) Remove the moulding release sheet from the face
of the moulding.
(3) Align the bosses with their corresponding holes on
the body, and press the moulding firmly.
(4) Install the 6 screws.
w/ Rear mudguard:
INSTALL FRONT MUDGUARD
Resin bumper type:
INSTALL FRONT BUMPER EXTENSION
Install the new protector as shown in the illustration.
Install the front bumper extension with the 4 nuts.
Torque: 5.0 N·m (51 kgf·cm, 44 in.·lbf)
Author :
BO-59
Date :
4830