Toyota Tundra 2005 Service - Repair - Maintenance page 2827

RS-60
SUPPLEMENTAL RESTRAINT SYSTEM
Hog Ring
Hog Ring
- SIDE AIRBAG ASSEMBLY (Power Adjuster Type)
INSTALLATION
HINT:
z
Use the same procedures for the RH side and LH side.
z
The procedures listed below are for the LH side.
NOTICE:
z
If the side airbag assembly has been dropped, or
there are cracks, dents or other defects in the case or
connector, replace the side airbag assembly with a
new one.
z
When installing the side airbag assembly, take care
it is not pinched between other parts.
z
Never use airbag parts from another vehicle. When
replacing parts, replace them with new ones.
1. INSTALL SEATBACK COVER AND PAD
(a) Install the seatback cover and pad to the seat frame as-
sembly.
(b) Install the 2 headrest supports to the seat frame assem-
bly.
(c) Install the hog rings to the seat frame assembly.
H24318
(d) Install the hog rings to the seat frame assembly.
(e) Close the fastener.
H24321
(f) Install the seatback cover belt to the seat frame assembly.
H24317
Author : Date :
RS12B-01
4475