Toyota Tundra 2005 Service - Repair - Maintenance page 2428

SA−14
Tire
SUSPENSION AND AXLE
REPLACEMENT
1.
2.
3.
(a)
(b)
HINT:
Keep the removed cap, valve core, nut and washer.
(c)
NOTICE:
Be careful not to damage the tire pressure monitor valve
Shoe
because of interference between the sensor and tire bead.
(d)
10 to 20 mm
(0.39 to 0.79 in.) (e)
F19824
(f)
HINT:
Check that there are no cracks or damage to the grommet. If
any damage is found, replace the grommet together with the
washer and nut.
4.
(a)
Print Surface
NOTICE:
S
S
F19825
− TIRE PRESSURE MONITOR VALVE
REMOVE FRONT TIRE
REMOVE REAR TIRE
REMOVE TIRE PRESSURE MONITOR VALVE
Remove the valve core and cap, and release air from the
tire.
After ensuring that air is sufficiently released, remove the
nut and washer that are used to fix the tire pressure moni-
tor valve sub−assy and drop the sensor inside the tire.
After dropping the tire pressure monitor valve sub−assy
into the tire, disengage the bead using the shoe of the tire
remover.
Remove the bead on the upper side.
Take out the sensor from the tire and remove the bead on
the lower side.
Remove the inner grommet from the tire pressure monitor
valve sub−assy.
INSTALL TIRE PRESSURE MONITOR VALVE
Insert the tire pressure monitor valve into the valve instal-
lation hole. Insert from the inside of the rim so that the print
surface can be seen.
Check that there is no visible deformation, damage or
other abnormalities on the transmitter.
Check that there is no foreign matter on the inner
grommet and around the rim hole.
SA2DC−01