Toyota Tundra 2005 Service - Repair - Maintenance page 3168

BO-54
BODY - BODY OUTSIDE MOULDING
INSTALLATION
1. CLEAN BODY MOUNTING SURFACE
(a) Using a heat light, heat the body mounting surface be-
tween 40 to 60°C (104 to 140°F).
NOTICE:
Do not heat the body excessively.
(b) Remove the double-sided tape from the body.
(c) Wipe off the stains with cleaner.
2. INSTALL MOULDING
BO6675
(a) Using a heat light, heat the body and moulding.
Heating Temperature:
Item
Body
Moulding
NOTICE:
Do not heat the body and moulding excessively.
(b) Remove the moulding peeling paper from the face of the
moulding.
NOTICE:
After removing the peeling paper, keep the exposed adhe-
sive away from dirt and other contaminants.
(c) Align the bosses with their corresponding holes on the
body, and press the moulding firmly.
NOTICE:
Do not apply excessive force onto the moulding, but steady
pressure with your thumbs.
BO5229
Temperature
40 to 60°C (104 to 14°F)
20 to 30°C (68 to 86°F)
Author : Date :
BO4H2-02
4825