Toyota Tundra 2005 Service - Repair - Maintenance page 2581

BRAKE − BRAKE FLUID
(5) Repeat the above procedure for each wheel to
bleed the air out of the brake line.
(d) Check fluid level in reservoir.
Check the fluid level and add fluid if necessary.
Fluid: SAE J1703 or FMVSS No. 116 DOT3
2. BLEED BRAKE LINE (W/O VSC, DOUBLE CAB)
HINT:
If any work is done on the brake system or if air is suspected in
the brake lines, bleed the air from the system.
NOTICE:
S
Bleed air from the chassis, 3rd chamber, and chassis
in order.
S
When the air is bled from the 3rd chamber, be sure to
run the engine.
S
If the brake fluid attaches to any painted surfaces,
wash it off immediately.
(a) Fill reservoir with brake fluid.
Check the fluid level in the reservoir after bleeding each
wheel. Add fluid, if necessary.
Fluid: SAE J1703 or FMVSS No. 116 DOT3
F07756
(b) Bleed brake line.
(1) Connect the vinyl tube to the brake caliper bleeder
plug.
(2) Depress the brake pedal several times, then loosen
the bleeder plug with the pedal held down.
(3) At the point when the fluid stops coming out, tighten
the bleeder plug, then release the brake pedal.
(4) Repeat (2) and (3) until all the air in the fluid has
been bled out.
F18780
Torque: (Bleeder plug) 11 N·m (110 kgf·cm, 8 ft·lbf)
(5) Repeat the above procedures for each wheel to
bleed the air out of the brake line.
BR−5