Toyota Tundra 2005 Service - Repair - Maintenance page 2863

RS-96
SUPPLEMENTAL RESTRAINT SYSTEM - AIRBAG SENSOR ASSEMBLY
REMOVAL
NOTICE:
z
If the wiring connector of the SRS is disconnected
with the ignition switch in the ON position, DTCs will
be recorded.
z
Never use airbag parts from another vehicle. When
replacing parts, replace them with new ones.
z
Never reuse an airbag sensor assembly if the airbag
has previously deployed in a collision.
1. PRECAUTION (SEE PAGE
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
Wait for 90 seconds after disconnecting the cable to prevent the
airbag working.
3. Standard cab:
Access cab (w/o Large type console box):
Double cab (Split type seat):
REMOVE LOWER CENTER COVER
(SEE PAGE
4. Access cab (w/ Large type console box):
Double cab:
REMOVE SHIFTING HOLE COVER
(SEE PAGE
5. Access cab (w/ Large type console box):
Double cab:
REMOVE UPPER CONSOLE PANEL
(SEE PAGE
6. Access cab (w/ Large type console box):
Double cab:
REMOVE REAR CONSOLE BOX
(SEE PAGE
7. Access cab (w/ Large type console box):
Double cab:
REMOVE FRONT CONSOLE BOX
(SEE PAGE
8. REMOVE AIRBAG SENSOR ASSEMBLY
(a) Disconnect the holder (with connectors) from the airbag
sensor assembly.
(b) Remove the 4 bolts and airbag sensor assembly.
H23231
RS-1
BO-1 11)
BO-1 11)
BO-1 11)
BO-1 11)
BO-1 11)
Author : Date :
RS0EY-15
AND RS-3 )
4511