Toyota Tundra 2005 Service - Repair - Maintenance page 2662

BR−86
BRAKE − HYDRAULIC BRAKE BOOSTER (w/ VSC)
DISASSEMBLY
NOTICE:
As high pressure is applied to the brake actuator tube No.
1, do not deform it.
1. REMOVE BRAKE ACTUATOR BRACKET NO. 1
(a) Using a hexagon wrench (5 mm), remove the screw and
brake actuator bracket No. 1 from the hydraulic brake
booster assembly.
F19550 Torque: 7.8 N·m (80 kgf·cm, 69 in.·lbf)
(b) Using a screwdriver, remove the fluid level warning switch
connector from the brake actuator bracket No. 1.
F19551
2. REMOVE MASTER CYLINDER RESERVOIR AS-
SEMBLY
(a) Remove the screw from the master cylinder reservoir as-
sembly.
Torque: 1.7 N·m (17 kgf·cm, 15 in.·lbf)
F19552
(b) Using a pin punch and hammer, remove the pin from the
master cylinder reservoir assembly.
(c) Pull out the master cylinder reservoir assembly from the
hydraulic brake booster assembly.
(d) Remove the 3 grommets from the master cylinder reser-
voir assembly.
(e) Remove the cap from the master cylinder reservoir as-
sembly.
F19553
3. REMOVE BRAKE ACTUATOR HOSE
(a) Using needle nose pliers, slide the 2 clips.
(b) Remove the brake actuator hose from the hydraulic brake
booster assembly.
F19554
BR1YB−01