Toyota Tundra 2005 Service - Repair - Maintenance page 2703

Washer
Retaining Ring
STEERING
REASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1.
2.
SST
(a)
(b)
(c)
(d)
(e)
R12807
(f)
NOTICE:
Do not bend the universal joint of the shaft assembly more
than 15°.
HINT:
Hold the main shaft assembly with your hand to prevent rota-
tion.
3.
4.
(a)
(b)
5.
(a)
(b)
- STEERING COLUMN (Standard Cab, Access Cab)
COAT PARTS INDICATED BY ARROWS WITH MOLYB-
DENUM DISULFIDE LITHIUM BASE GREASE (See
page SR-12 )
INSTALL MAIN SHAFT ASSEMBLY
Non-tilt steering column:
Install the compression spring and spring retainer.
Tilt steering column:
Install the inner race, upper bearing inner race seat, com-
pression spring and spring retainer.
Install a new retaining ring to the main shaft assembly.
Install the washer of SST to the main shaft assembly.
Set SST on the main shaft assembly, as shown in the il-
lustration.
SST 09612-07010
Using SST, push down the retaining ring until it fits into the
shaft groove and install the main shaft assembly.
INSTALL MAIN SHAFT STOPPER
Tilt steering column:
INSTALL STEERING COLUMN HOUSING SUPPORT
Install 2 new tilt No.1 stoppers and the steering column
housing support.
Install 4 new torx® bolts.
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
Non-tilt steering column:
INSTALL COLUMN UPPER TUBE WITH MAIN SHAFT
ASSEMBLY
Install the column upper tube with the main shaft assem-
bly to the column tube assembly.
Install 4 new torx® bolts.
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
Author :
SR-25
SR1KK-02
Date :
4351