Toyota Tundra 2005 Service - Repair - Maintenance page 2769

RS-2
SUPPLEMENTAL RESTRAINT SYSTEM
z
If the steering wheel pad, front passenger airbag assembly, side airbag assembly, curtain
shield airbag assembly, airbag sensor assembly, front airbag sensor, side airbag sensor as-
sembly, curtain shield airbag sensor assembly, seat position sensor assembly or occupant
classification ECU has been dropped, or if there are any cracks, dents or other defects in the
case, bracket or connector, replace it with a new one.
z
Use a volt/ohmmeter with high impedance (10 kΩ/V minimum) for troubleshooting the electrical
circuits.
z
Information labels are attached to the periphery of the SRS components. Follow the instruc-
tions in the caution.
z
After work on the SRS is completed, perform the SRS warning light check (see page
z
When the negative (-) terminal cable is disconnected from the battery, the memory will be
cleared. Because of this, be sure to make a record of the contents memorized in each system
before starting work. When work is finished, adjust each system as it was before. Never use
a back-up power supply from outside the vehicle to avoid erasing the memory in any system.
- SRS AIRBAG
Author :
DI-1859
Date :
4417
).