Toyota Tundra 2005 Service - Repair - Maintenance page 2490

Hide thumbs Also See for Tundra 2005:

Table of Contents

SUSPENSION AND AXLE

Before installing the bushing, set it in the correct direction, as

shown in the illustration.

Before installing the bushing, set it in the correct direction, as

shown in the illustration.

Installation

At the time of installation, use a torque wrench with a fulcrum

length of 345 mm (13.58 in.).

FRONT LOWER SUSPENSION ARM

REPLACE BUSHING

Using a chisel and hammer, pry up the flange of the bush-

Using SST and a press, remove the bushing.

09613−26010, 09632−36010, 09950−00020

Using SST, a press and steel plate, install a new No. 1

09502−12010, 09631−12090

Using SST, a press and steel plate, install a new No. 2

09631−12090, 09950−60020 (09951−00680)

REPLACE NO. 1 AND NO. 2 SPRING BUMPERS

Remove the front wheel.

Using SST, replace the No. 1 spring bumper.

Torque: 23 N·m (235 kgf·cm, 17 ft·lbf)