Toyota Tundra 2005 Service - Repair - Maintenance page 3185

Standard Cab
Access Cab
LH: 4 Clips
RH: 3 Clips
Double Cab
Clip
BODY - WINDSHIELD
REMOVAL
HINT:
While supporting the hood by hand, remove the hood support
from the hood.
1. REMOVE INNER REAR VIEW MIRROR
Remove the inner rear view mirror as shown in the illustration.
H11169
2. REMOVE ASSIST GRIPS
(a) Using a screwdriver, remove the caps.
HINT:
Tape the screwdriver tip before use.
(b) Driver side:
Using a torx® driver, remove the 2 torx® screws and assist
grip.
Torx® driver: T30 (Part No.09041-00030 or locally
manufactured tool)
H09484
(c) Standerd cab, Access cab, Passenger side:
Using a torx® driver, remove the 4 torx® screws and 2 as-
sist grips.
Torx® driver: T30 (Part No.09041-00030 or locally
manufactured tool)
(d) Double cab cab, Passenger side:
Using a torx® driver, remove the 2 torx® screws and assist
grips.
Torx® driver: T30 (Part No.09041-00030 or locally
manufactured tool)
3. REMOVE FRONT PILLAR GARNISH
(a) Using a screwdriver, remove the front pillar garnish.
HINT:
Tape the screwdriver tip before use.
(b) Employ the same manner described above to the other
side.
4. REMOVE SUN VISORS
(a) Remove the 4 screws and 2 sun visors.
(b) w/ Light:
Disconnect the connector.
5. REMOVE SUB-VISORS
Remove the 4 screws and 2 sub-visors.
H24930
Author : Date :
BO-71
BO4Q3-02
4842