Toyota Tundra 2005 Service - Repair - Maintenance page 2492

SA−78
Matchmarks
A
SUSPENSION AND AXLE
Matchmarks
R13282
C
B
F07278
− FRONT LOWER SUSPENSION ARM
INSTALLATION
1. INSTALL LOWER SUSPENSION ARM TO CHASSIS
FRAME
Install the lower suspension arm with the 2 cams, bolts and cam
plates while slightly shifting the power steering gear rearward.
Torque: 130 N·m (1,325 kgf·cm, 96 ft·lbf)
NOTICE:
Do not damage the power steering gear tubes.
HINT:
After stabilizing the suspension, align the matchmarks on the
front and rear cam plates and chassis frame, and torque the
bolts.
2. CONNECT LOWER BALL JOINT TO LOWER SUSPEN-
SION ARM
Connect the lower ball joint and install the nut and a new cotter
pin.
Torque: 140 N·m (1,450 kgf·cm, 103 ft·lbf)
If the holes for the cotter pin are not aligned, tighten the nut fur-
ther up to 60°.
3. CONNECT SHOCK ABSORBER TO LOWER SUSPEN-
SION ARM
Torque: 135 N·m (1,400 kgf·cm, 100 ft·lbf)
4. CONNECT STABILIZER BAR LINK TO LOWER SUS-
PENSION ARM
Torque: 69 N·m (700 kgf·cm, 51 ft·lbf)
HINT:
If the ball joint turns together with the nut, use a hexagon (6 mm)
wrench to hold the stud.
5. INSTALL POWER STEERING GEAR
Torque:
A bolt: 165 N·m (1,700 kgf·cm, 122 ft·lbf)
B nut: 130 N·m (1,350 kgf·cm, 96 ft·lbf)
C bolt and nut: 165 N·m (1,700 kgf·cm, 122 ft·lbf)
6. CONNECT RH AND LH TIE ROD ENDS
Connect the RH and LH tie rod ends to the lower ball joints with
the nuts and new cotter pins.
Torque: 91 N·m (930 kgf·cm, 67 ft·lbf)
If the holes for the cotter pin are not aligned, tighten the nut fur-
ther up to 60°.
7. INSTALL RH AND LH FRONT WHEELS
Torque: 110 N·m (1,150 kgf·cm, 83 ft·lbf)
8. CHECK FRONT WHEEL ALIGNMENT (See page
SA−5)
SA1KK−03