Toyota Tundra 2005 Service - Repair - Maintenance page 2501

INSTALLATION
1. INSTALL LOWER BALL JOINT WITH LOWER BALL JOINT DUST COVER PROTECTOR
(a) While lifting the upper suspension arm and steering knuckle, install the lower ball joint.
(b) Install the lower ball joint dust cover protector.
(c) Temporarily install the 4 bolts to the lower ball joint.
(d) Install the set nut to hold the lower ball joint to the lower suspension arm and a new cotter pin.
Torque: 159 N·m (1,620 kgf·cm, 117 ft·lbf)
If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
2. CONNECT TIE ROD END
Connect the tie rod end to the lower ball joint with the nut and a new cotter pin.
Torque: 91 N·m (930 kgf·cm, 67 ft·lbf)
If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
3. TIGHTEN LOWER BALL JOINT SET 4 BOLTS
Torque: 65 N·m (662 kgf·cm, 48 ft·lbf)
4. INSTALL FRONT WHEEL
Torque: 110 N·m (1,150 kgf·cm, 83 ft·lbf)
5. CHECK FRONT WHEEL ALIGNMENT (See page SA−5)
SUSPENSION AND AXLE − FRONT LOWER BALL JOINT
SA−87
SA0B0−03