Toyota Tundra 2005 Service - Repair - Maintenance page 2807

RS-40
SUPPLEMENTAL RESTRAINT SYSTEM
SST
SST
SST
10 m (33 ft) or more
Battery
AB0158
H23215
H23216
Battery
R13455
- FRONT PASSENGER AIRBAG ASSEMBLY
1. AIRBAG DEPLOYMENT WHEN SCRAPPING VE-
HICLE
(a) Check the function of the SST (see step 1-(a) on page
RS-25 ).
(b) Precaution (see page
(c) Disconnect the cable from the negative battery terminal.
Wait for 90 seconds after disconnecting the cable to prevent the
airbag working.
(d) Remove the glove compartment door
(see page BO-1
(e) Remove the lower No. 2 finish panel
(see page BO-1
(f) Disconnect the airbag connector (yellow colored one)
from the front passenger airbag assembly.
(1) Using a clip remover, disengage the connector
clamp.
(2) Disconnect the airbag connector.
NOTICE:
When handling the airbag connector, take care not to dam-
age the airbag wire harness.
(g) Install the SST.
(1) Connect the SST connector to the front passenger
airbag assembly.
SST 09082-00700, 09082-00780
NOTICE:
To avoid damaging the SST connector and wire harness,
do not lock the secondary lock of the twin lock.
(2) Move the SST at least 10 m (33 ft) away from the ve-
hicle side window.
(3) Maintaining enough clearance for the SST wire har-
ness in the front side window, close all doors and
windows of the vehicle.
NOTICE:
Take care not to damage the SST wire harness.
(4) Connect the red clip of the SST to the battery posi-
tive (+) terminal and the black clip of the SST to the
negative (-) terminal.
Author :
RS-1 and RS-3
11).
11).
Date :
).
4455