Toyota Tundra 2005 Service - Repair - Maintenance page 2796

Hide thumbs Also See for Tundra 2005:

Table of Contents

SUPPLEMENTAL RESTRAINT SYSTEM

2 Times or more

STEERING WHEEL PAD AND SPIRAL CABLE

Using 3 wire harnesses, wind wire harness at least

2 times each around the bolts installed on the left

and right sides of the steering wheel pad.

Tightly wind the wire harness around the bolts so that

there is no slack.

Make sure that the wire harness is tight. If there is

slack in wire harness, the steering wheel pad may be-

come loose due to the shock when the airbag is

Face the airbag deployment side of the steering

wheel pad upward. Separately tie the left and right

sides of the steering wheel pad to the disc wheel

through the hub nut holes. Position the SST con-

nector so that it hangs downward through the hub

hole in the disc wheel.

Make sure that the wire harness is tight. If there is

slack in wire harness, the steering wheel pad may be-

come loose due to the shock when the airbag is

Always tie down the steering wheel pad with the air-

bag deployment side facing upward.

The disc wheel will be marked by the airbag deployment,

so use an extra disc wheel.

Install the SST.

Place the disc wheel on level ground.

Connect the SST connector.

To avoid damaging the SST connector and wire harness,

do not lock the secondary lock of the twin lock. Also, se-

cure some slack for the SST wire harness inside the disc