Full Belt Length Minus
200 mm
15°
Rear No. 1 Seat
Outer Center
Seat Belt
Rear No. 1 Seat
Outer Center
Seat Belt
BODY
(f)
(g)
N10070
(h)
45°
If a problem is found, replace the assembly.
BO0633
4.
40°
(a)
(b)
(c)
Retractor
H05710
(d)
H05731
-
SEAT BELT
Retract the whole belt, then pull out the belt until 200 mm
(7.87 in.) of belt remains retracted.
Tilt the retractor slowly.
Make sure that the belt can be pulled out at a tilt of 15 de-
grees or less, and cannot be pulled out at over 45 de-
grees.
INSPECT REAR NO. 1 SEAT CENTER BELT
After extracting 300 mm (11.81 in.), check that the belt
locks when suddenly extracted.
Check that the belt can be extracted 300 mm (11.81 in.)
without being locked when the seat is reclined as shown
in the illustration.
Check that the belt is locked when the belt is extracted by
a certain amount under condition (a).
When folding down the seatback forward and extracting
the seat belt slowly, check that the belt is locked after a
certain length (approximately 500 mm (19.69 in.)) of the
belt has been extracted.
Author :
BO-235
Date :
5006