Toyota Tundra 2005 Service - Repair - Maintenance page 3361

SST
SST
Battery
10 m or more
BODY - SEAT BELT PRETENSIONER
(d) Access cab:
Disconnect the pretensioner connector.
(1) Remove the front door scuff plate.
(2) Remove the rear door scuff plate.
(3) Remove the front seat outer belt floor anchor.
(4) Remove the front seat outer belt shoulder belt.
(5) Remove the roof side rail garnish.
(6) Remove the front door rear scuff plate and cover.
(7) Disconnector the pretensioner connector as shown
H11401
in the illustration.
(e) Double cab:
Disconnect the pretensioner connector.
(1) Remove the front door scuff plate.
(2) Remove the back door scuff plate.
(3) Remove the lower center pillar garnish.
(4) Disconnect the pretensioner connector as shown in
the illustration.
H18975
(f) Install the SST.
(1) Buckle the front seat belt and check that there is no
looseness and slack in the front seat inner belt and
front seat outer belt.
(2) Connect the 2 SST, then connect them to the seat
belt pretensioner.
SST 09082-00700, 09082-00740
NOTICE:
To avoid damaging the SST connector and wire harness,
H11402
do not lock the secondary lock of the twin lock.
(3) Move the SST to at least 10 m (33 ft) away from the
front of the vehicle.
(4) Close all the doors and windows of the vehicle.
HINT:
Do not close the window fully. Allow clearance for inserting the
SST wire harness.
NOTICE:
Take care not to damage the SST wire harness.
(5) Connect the SST red clip to the battery positive (+)
R13455
terminal and the black clip to the negative (-) termi-
nal.
(g) Activate the seat belt pretensioner.
(1) Confirm that no one is inside the vehicle or within 10
m (33 ft) area around the vehicle.
(2) Press the SST activation switch and activate the
seat belt pretensioner.
HINT:
The seat belt pretensioner operates simultaneously as the LED
of the SST activation switch lights up.
Author : Date :
BO-247
5018