Toyota Tundra 2005 Service - Repair - Maintenance page 2752

SR-74
SST
SST
Matchmarks
STEERING
DISASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1.
SST
(a)
(b)
F13620
2.
Using SST, 2 bolts and nuts, secure the gear assembly in a vise,
as shown in the illustration.
Bolt
HINT:
Use 2 of the same type of SST.
Bolt
F06746
3.
(a)
(b)
(c)
F06747
4.
(a)
(b)
HINT:
Mark the RH and LH boots.
NOTICE:
Be careful not to damage the boot.
F06748
- POWER STEERING GEAR
REMOVE 2 TURN PRESSURE TUBES
Using SST, remove the 2 turn pressure tubes.
SST 09023-38401
Remove the 4 O-rings from the tubes.
SECURE PS GEAR ASSEMBLY IN VISE
SST 09612-00012
Reference:
Bolt: 90105-10346
Nut: 90170-10198
REMOVE RH AND LH TIE ROD ENDS AND LOCK
NUTS
Put matchmarks on the tie rod end, lock nut and rack end.
Loosen the lock nut, remove the tie rod end and lock nut.
Perform the same procedure on the other side.
REMOVE RH AND LH CLIPS, RACK BOOTS AND
CLAMPS
Using a screwdriver, loosen the 2 clamps.
Remove the 2 clips and boots.
Author :
SR0V9-06
Date :
4400