BO-160
BODY
-
FRONT SEAT (Separate Type: Manual Adjuster)
REASSEMBLY
CAUTION:
Wear safety gloves, because the sharp edges and surfaces
of the seat frame may cause injury to the hands.
HINT:
z
The procedures listed below are for the LH side.
z
A bolt without a torque specification is shown in the stan-
dard bolt chart (see page
1.
Driver's seat:
INSTALL SEAT POSITION SENSOR
(SEE PAGE
2.
INSTALL RH AND LH SEAT CUSHION LOWER
SHIELDS
3.
INSTALL RH AND LH LOWER RECLINING ADJUSTER
INSIDE COVERS
(a)
Install the LH lower reclining adjuster inside cover with the
screw.
(b)
Perform the same procedure on the other side.
H24343
4.
INSTALL RH AND LH UPPER RECLINING ADJUSTER
INSIDE COVERS
(a)
Install the LH upper reclining adjuster inside cover with
the screw.
(b)
Perform the same procedure on the other side.
H24342
5.
INSTALL SEAT CUSHION COVER
Install the seat cushion cover to the seat cushion pad with the
hog rings.
HINT:
When installing the hog rings, take as much care as possible to
prevent wrinkles.
6.
INSTALL SEAT CUSHION COVER AND PAD
(a)
Install the seat cushion cover with seat cushion pad, and
latch the seat cushion cover hooks.
H24395
SS-2
).
RS-122
)
Author :
Date :
BO4SE-01
4931