Toyota Tundra 2005 Service - Repair - Maintenance page 2463

Boiling Water
SST
SUSPENSION AND AXLE
(b) Heat the ring gear to about 100°C (212°F) in boiling wa-
ter.
(c) Carefully take the ring gear out of the boiling water.
(d) After the moisture on the ring gear has completely evapo-
rated, quickly install the ring gear to the differential case.
HINT:
Align the matchmarks on the ring gear and differential case.
(e) Temporarily install 5 new lock plates and 10 bolts so that
the bolt holes in the ring gear and differential case are
SA2160
aligned.
(f) After the ring gear has cooled sufficiently, torque the ring
gear set bolts.
Torque: 97 N·m (985 kgf·cm, 71 ft·lbf)
(g) Using a chisel and hammer, stake the 5 lock plates.
HINT:
Stake the claws of the lock plates to fix the bolts. For the claw
contacting the protruding portion of the bolt, stake only the half
of it along the tightening direction.
Z02483
5. INSTALL SIDE BEARINGS
Using SST and a press, install the bearings into the differential
case.
SST
SST
6. INSTALL SIDE BEARING OUTER RACES
If replacing the side bearings, fit the thinnest new plate washers
to each bearing outer race.
If reusing the bearings, fit the new washers with the same thick-
ness as removed.
R13784
(a) Install a new plate washer to the side bearing retainer.
(b) Using SST and a press, install the bearing outer race.
SST
(c) Install a new plate washer to the differential carrier.
R13375
− FRONT DIFFERENTIAL CARRIER
09226−10010
09950−60020 (09951−00790),
09950−70010 (09951−07150)
SA−49