Toyota Tundra 2005 Service - Repair - Maintenance page 2816

SUPPLEMENTAL RESTRAINT SYSTEM
H24311
H24312
- SIDE AIRBAG ASSEMBLY (Power Adjuster Type)
REMOVAL
HINT:
z
Use the same procedures for the RH side and LH side.
z
The procedures listed below are for the LH side.
NOTICE:
z
If the wiring connector of the SRS is disconnected
and the ignition switch is in the ON or ACC position,
DTCs will be recorded.
z
Never use airbag parts from another vehicle. When
replacing parts, replace them with new ones.
1. PRECAUTION (SEE PAGE
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
Wait for 90 seconds after disconnecting the cable to prevent the
airbag working.
3. REMOVE SEAT TRACK COVERS
Using a screwdriver, remove the 2 seat track covers.
HINT:
Tape the screwdriver tip before use.
4. REMOVE FRONT SEAT
(a) Remove the 4 bolts.
(b) Disconnect the connectors.
(c) Remove the front seat.
CAUTION:
Be careful not to damage the body.
5. REMOVE HEADREST
6. REMOVE SLIDE KNOB AND RECLINING KNOB
Using a screwdriver, remove the slide knob and reclining knob.
HINT:
Tape the screwdriver tip before use.
7. REMOVE SEAT CUSHION LOWER SHIELD, SEAT
CUSHION OUTER SHIELD AND SEAT CUSHION IN-
NER SHIELD
(a) Remove the screw from the seat cushion outer shield.
(b) Perform the same procedure as for the seat cushion inner
shield.
Author :
RS-1 AND RS-3 )
Date :
RS-49
RS127-01
4464