Toyota Tundra 2005 Service - Repair - Maintenance page 2558

SA−144
Thickness
Mark
87
88
89
90
91
92
93
94
95
96
97
98
99
00
SUSPENSION AND AXLE
R04554
mm (in.) Mark
1.87 (0.0736) 01
1.88 (0.0740) 02
1.89 (0.0744) 03
1.90 (0.0748) 04
1.91 (0.0752) 05
1.92 (0.0756) 06
1.93 (0.0760) 07
1.94 (0.0764) 08
1.95 (0.0768) 09
1.96 (0.0772) 10
1.97 (0.0776) 11
1.98 (0.0780) 12
1.99 (0.0783) 13
2.00 (0.0787) 14
SST
R11163
− REAR DIFFERENTIAL CARRIER (w/ LSD)
If the teeth are not contacting properly, use the following table
to select a proper washer for correction.
Washer thickness:
Thickness
mm (in.)
2.01 (0.0791)
2.02 (0.0795)
2.03 (0.0799)
2.04 (0.0803)
2.05 (0.0807)
2.06 (0.0811)
2.07 (0.0815)
2.08 (0.0819)
2.09 (0.0823)
2.10 (0.0827)
2.11 (0.0831)
2.12 (0.0835)
2.13 (0.0839)
2.14 (0.0843)
18. REMOVE COMPANION FLANGE (See page SA−126)
19. REMOVE FRONT BEARING (See page SA−126)
20. INSTALL NEW BEARING SPACER, 2 WASHERS AND
FRONT BEARING
(a) Install a new bearing spacer and 2 washers, and place the
front bearing.
(b) Using SST and the companion flange, install the front
bearing then remove the companion flange.
SST 09950−30012 (09951−03010, 09953−03010,
09954−03010, 09955−03030, 09956−03050)
21. INSTALL NEW OIL SEAL
(a) Coat a new oil seal lip with MP grease.
Thickness
Mark
15
16
17
18
19
20
21
22
23
24
25
26
27
28
mm (in.)
2.15 (0.0846)
2.16 (0.0850)
2.17 (0.0854)
2.18 (0.0858)
2.19 (0.0862)
2.20 (0.0866)
2.21 (0.0870)
2.22 (0.0874)
2.23 (0.0878)
2.24 (0.0882)
2.25 (0.0886)
2.26 (0.0890)
2.27 (0.0894)
2.28 (0.0898)