SA−108
SST
SUSPENSION AND AXLE
6.
MEASURE DRIVE PINION PRELOAD
Using a torque wrench, measure the preload of the drive pinion
using the backlash between the drive pinion and ring gear.
Preload (at starting):
0.5 − 0.8 N·m (5 − 8 kgf·cm, 4.3 − 6.9 in.·lbf)
7.
CHECK TOTAL PRELOAD
Using a torque wrench, measure the total preload with the teeth
of the drive pinion and ring gear in contact.
Total preload (at starting):
SA2352
Drive pinion preload plus 0.4 − 0.6 N·m (4 − 6 kgf·cm,
3.5 − 5.2 in.·lbf)
If necessary, disassemble and inspect the differential.
8.
REMOVE COMPANION FLANGE
(a)
Using a chisel and hammer, unstake the staked part of the
nut.
(b)
Using SST to hold the flange, remove the nut.
SST
SST
SA2349
(c)
Using SST, remove the companion flange.
SST
SST
R11391
9.
REMOVE FRONT OIL SEAL
Using SST, remove the oil seal from the differential carrier.
SST
SA2348
−
REAR DIFFERENTIAL CARRIER
09330−00021
09950−30012 (09951−03010, 09953−03010,
09954−03010, 09955−03030, 09956−03050)
09308−10010