Toyota Tundra 2005 Service - Repair - Maintenance page 2700

SR-22
Plate Washer A
Screw
Plate Washer B
Retaining Ring
STEERING
10.
(a)
SST
F06734
(b)
NOTICE:
Do not bend the universal joint of the main shaft assembly
more than 15°.
(c)
11.
(a)
(b)
12.
13.
(a)
SST
(b)
NOTICE:
Do not bend the universal joint of the shaft assembly more
than 15°.
HINT:
R12472
Hold the shaft assembly with your hand to prevent rotation.
(c)
(d)
(e)
- STEERING COLUMN (Standard Cab, Access Cab)
Tilt steering column:
REMOVE STEERING COLUMN HOUSING WITH MAIN
SHAFT ASSEMBLY
Set SST, 2 plate washers (18 and 36 mm outer diameter)
and a screw (4.0 mm diameter, 0.7 mm pitch, 15.0 mm
length), as shown in the illustration. Then remove the 2
pivot pins.
SST 09910-00015 (09911-0001 1, 09912-00010)
Reference
Plate washer A (18 mm): 90562-04012
Plate washer B (36 mm): 90201-10201
Screw: 90154-40015
Remove the column housing with the shaft assembly from
the column tube assembly.
Remove the tilt spring and spring guide.
Tilt steering column:
REMOVE STEERING COLUMN HOUSING SUPPORT
Remove the 4 torx® bolts.
Remove the 2 tilt No.1 stoppers and steering column
housing support.
REMOVE MAIN SHAFT STOPPER
REMOVE MAIN SHAFT ASSEMBLY
Install SST to the main shaft assembly, as shown in the
illustration.
SST 09612-07010
Using SST, compress the compression spring.
Using a screwdriver, remove the retaining ring.
Non-tilt steering column:
Remove the spring retainer and compression spring.
Tilt steering column:
Remove the spring retainer, compression spring, upper
bearing inner race seat and inner race.
Author : Date :
4348