Toyota Tundra 2005 Service - Repair - Maintenance page 3005

BE-96
Warning Light
Ignition
Switch
Battery
Double Cab
Except Double Cab
Except Bench Seat
BODY ELECTRICAL
31.
(a)
(b)
If the warning light does not light up, inspect the bulb.
BE0044
32.
Check that continuity exists between terminals 1 and 2 when
pressing the sensing part.
If the continuity is not as specified, replace the sensor.
I27489
33.
Bench Seat
Check that continuity exists between terminals 1 and 2 when
pressing the sensing part.
If the continuity is not as specified, replace the sensor.
I27488
- COMBINATION METER
INSPECT OPEN DOOR WARNING LIGHT
Disconnect the connector from the door courtesy switch
and ground terminal on the wire harness side.
Turn the ignition switch ON, and check that the warning
light lights up.
Double cab (Passenger's seat only):
INSPECT SEAT BELT WARNING OCCUPANT DETEC-
TION SENSOR CONTINUITY
Except double cab (Passenger's seat only):
INSPECT SEAT BELT WARNING OCCUPANT DETEC-
TION SENSOR CONTINUITY
Author : Date :
4653