Toyota Tundra 2005 Service - Repair - Maintenance page 2614

BR−38
INSTALLATION
1. INSTALL BRAKE BOOSTER
(a) Install a new gasket to the brake booster.
(b) Install the brake booster bracket and 2 stopper rings to the brake booster.
(c) Install the booster and a new gasket.
(d) Install the clevis to the operating rod.
(e) Install and torque the booster installation nuts.
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)
(f) Install the clevis pin into the clevis and brake pedal, and install the clip to the clevis pin.
(g) Connect the vacuum hose to the brake booster.
2. INSTALL NO. 2 HEATER TO REGISTER DUCT, LOWER FINISH PANEL, COWL SIDE TRIM LH AND
SCUFF PLATE (See page BO−120)
NOTICE:
S
Do not adjust the brake booster push rod.
S
Do not change the combination of the diameter converting unit and brake.
3. INSTALL MASTER CYLINDER (See page BR−30)
4. FILL BRAKE RESERVOIR WITH BRAKE FLUID AND BLEED BRAKE SYSTEM
(See page BR−4)
5. CHECK FOR FLUID LEAKAGE
6. CHECK AND ADJUST BRAKE PEDAL (See page BR−10)
7. DO OPERATIONAL CHECK (See page BR−35)
BRAKE − BRAKE BOOSTER ASSEMBLY (Double Cab)
BR1XH−02