Toyota Tundra 2005 Service - Repair - Maintenance page 2856

SUPPLEMENTAL RESTRAINT SYSTEM
Stripped Wire Harness Section
Width
Inner
Diameter
(c)
H23223
(d)
Wire Harness
Diameter
CAUTION:
If the wire harness is too thin or an alternative object is
used to tie down the curtain shield airbag assembly, it may
be snapped by the shock when the airbag is deployed. Al-
ways use a wire harness for vehicle use with an area of at
AB0163
least 1.25 mm
HINT:
To calculate the area of the stripped wire harness section:
H23224
CAUTION:
z
z
NOTICE:
The tire will be marked by the airbag deployment, so use an
extra tire.
- CURTAIN SHIELD AIRBAG ASSEMBLY
Cut off the deployment section of the curtain shield airbag
assembly.
Using a service-purpose wire harness for the vehicle, tie
down the front passenger airbag assembly to the tire.
Wire harness: Stripped wire harness section
2
1.25 mm or more (0.0019 in
2
(0.0019 in
Area = 3.14 x (Diameter)
(1) Position the curtain shield airbag assembly inside
the tire with the airbag deployment side facing in-
side.
Tire size: Must exceed the following dimensions:
Width: 185 mm (7.28 in.)
Inner diameter: 360 mm (14.17 in.)
Make sure that the wire harness is tight. If there is
slack in wire harness, the curtain shield airbag as-
sembly may become loose due to the shock when the
airbag is deployed.
Always tie down the curtain shield airbag assembly
with the airbag deployment side facing inside.
Author :
2
. or more)
2
.).
2
divided by 4
Date :
RS-89
4504