Toyota Tundra 2005 Service - Repair - Maintenance page 2422

SA−8
A
D
Front
C
A B
Front
A: Inside
B: Outside
SUSPENSION AND AXLE
5.
B
If the toe−in is not within the specified value, adjust the rack
ends.
6.
(a)
SA3213
(b)
(c)
HINT:
Try to adjust the toe−in to the center of the specified value.
R13228
(d)
(e)
(f)
HINT:
Make sure that the boots are not twisted.
R13229
(g)
B A
Wheel turning angle:
If the right and left wheel turning angles differ from the specified
value, readjust the toe−in and wheel angle within the specified
value. At this time, make sure that the lengths of the right and
left rack ends are the same.
FA0018
− FRONT WHEEL ALIGNMENT
INSPECT TOE−IN (See page SS−59)
ADJUST TOE−IN AND WHEEL ANGLE
Remove the 2 clips.
Loosen the tie rod end lock nuts.
Turn the right and left rack ends by an equal amount to
adjust the toe−in.
Make sure that the lengths of the right and left rack ends
are the same.
Rack end length difference: 1.5 mm (0.059 in.) or less
Tighten the tie rod end lock nuts.
Torque: 55 N·m (560 kgf·cm, 41 ft·lbf)
Place the boots on the seats and install the clips.
Inspect the wheel angle See page SS−59.
Turn the steering wheel fully and measure the turning
angle.
Rack end length difference: 1.5 mm (0.059 in.) or less