Toyota Tundra 2005 Service - Repair - Maintenance page 2745

Inscribed Mark
F04809
Round End
F04810
F01507
STEERING - POWER STEERING VANE PUMP (2UZ-FE)
REASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1. COAT PARTS INDICATED BY ARROWS WITH POWER
STEERING FLUID (See page
2. INSTALL VANE PUMP SHAFT WITH VANE PUMP
PULLEY
3. INSTALL STRAIGHT PINS
Using a plastic hammer, tap in 2 new pins into the front housing.
NOTICE:
Be careful not to damage the pins.
4. INSTALL CAM RING
Install the cam ring with the inscribed mark facing outward.
HINT:
Align the hole of the cam ring with the one of the straight pins.
5. INSTALL VANE PUMP ROTOR
(a) Install the vane pump rotor with the inscribed mark facing
outward.
(b) Install a new snap ring to the vane pump shaft.
6. INSTALL VANE PLATES AND GASKET
(a) Install the 10 plates with the round end facing outward.
(b) Install a new gasket on the front housing.
NOTICE:
Be careful of the direction of the gasket.
7. INSTALL SIDE PLATE
Align the hole of the plate with the hole of the 2 straight pins.
8. INSTALL WAVE WASHER
Install the washer so that the protrusions fit into the slots in the
side plate.
9. INSTALL REAR HOUSING
(a) Coat 2 new O-rings with power steering fluid and install
them to the rear housing.
(b) Install the rear housing with the 4 bolts.
Torque: 24 N·m (240 kgf·cm, 17 ft·lbf)
Author :
SR-67
SR0V8-05
SR-59 )
Date :
4393