Toyota Tundra 2005 Service - Repair - Maintenance page 3104

Hide thumbs Also See for Tundra 2005:

Table of Contents

BODY ELECTRICAL

Before entering registration mode, the indicator shows the dis-

play. After entering registration mode, the indicator flashes at

a cycle of 1 Hz. For a "rolling code" type system, after entering

registration mode, the indicator flashes at a cycle of 8.8 Hz for

1.6 seconds, and then the indicator flashes at a cycle of 1 Hz.

If transmitter code registration fails: 1) the original trans-

mitter's battery may be low or need to be replaced, or 2)

the system to be registered may not be compatible with

the garage door opener.

Some transmitter's signals stop after 1 to 2 seconds. For

these types of transmitters: 1) press and hold one of the

garage door opener switches, and 2) press and release

(cycle) the transmitter switch every 2 seconds. Check if

the transmitter code was successfully registered.

After entering the garage door opener registration mode,

transmitter code registration must be completed within 90

seconds. If 90 seconds elapses, the garage door opener

will enter low power mode (See step (c)).

GARAGE DOOR OPENER SYSTEM (Double Cab)

Select a switch of the garage door opener for the

transmitter code registration.

Press and hold the selected switch for 20 seconds.

Then, the garage door opener enters registration

After the garage door opener has entered registra-

tion mode, bring the original transmitter of the sys-

tem to be registered within 1 to 3 inches of the ga-

rage door opener and press and hold one of the

garage door opener switches. Then press the origi-

nal transmitter switch.

If the transmitter code registration was successful,

the indicator of the garage door opener flashes at

a cycle of 5.6 Hz. If no malfunction occurs, release

both the garage door opener switch and the original

transmitter switch.