Toyota Tundra 2005 Service - Repair - Maintenance page 3203

Protective Tape
H11360
Protective Tape
H11249
H11250
Protective Tape
H11353
BODY - BACK WINDOW GLASS
23. Fix type, Slide type, Power slide type:
REMOVE BACK WINDOW GLASS
(a) Remove the 4 nuts.
(b) Using a screwdriver, remove the weatherstrip from the
body.
HINT:
Tape the screwdriver tip before use.
NOTICE:
Be careful not to damage the body paint.
(c) From the interior, insert piano wore between the vehicle
body and glass.
(d) Tie objects tat can serve as handle (for example, wooden
blocks) to all wire ends.
HINT:
Apply protective tape to the outer surface to prevent the surface
from being scratched.
NOTICE:
When separating the glass, take care not to damage the
body paint and exterior.
(e) Cut off the adhesive by pulling the piano wire around it.
HINT:
Cut off the adhesive on the areas as shown in the illustration but
leave the adhesive where the stud bolts exist.
(f) Pass piano wire through as shown in the illustration, and
cut off the adhesive on the part adhered to the stud bolts.
(g) Remove the glass.
NOTICE:
Leave as much of the adhesive on the body as possible
when removing the glass.
Author :
BO-89
Date :
4860