Toyota Tundra 2005 Service - Repair - Maintenance page 2461

5.5 ± 0.3 mm
(0.217 ± 0.012 in.)
SUSPENSION AND AXLE
(2)
SST
SST
R13420
(e) Install a new intermediate shaft No. 2 bearing.
(1)
SST
(2)
SST
(f) Install the intermediate shaft No. 2 to the tube.
(1)
(2)
R13421
(g) Install a new oil seal.
(1)
SST
Oil seal drive in depth: 5.5 ± 0.3 mm (0.217 ± 0.012 in.)
(2)
SST
R13419
(h) Install the clutch hub.
(1)
(2)
SA0335
− FRONT DIFFERENTIAL CARRIER
Using SST, a brass bar and press, remove the bear-
ing.
09950−00020
Using SST and a press, install a new bearing.
09309−37010
Using a snap ring expander, install a new snap ring.
Install the shaft into the tube.
Using needle nose pliers, install a new snap ring.
Using SST and a plastic hammer, install a new oil
seal.
09223−15020
Coat the oil seal lip with MP grease.
Install the clutch hub to the shaft.
Using a snap ring expander, install a new snap ring.
SA−47