Toyota Tundra 2005 Service - Repair - Maintenance page 3047

BE-138
3. PASSIVE ARMING MODE
_
Passive arming mode can be switched ON/OFF by the hand-held tester.
_
The alarm is initially set (when shipped from factory) to active arming mode (not passive arming mode).
_
During passive arming mode, the theft deterrent system goes into the armed state even if the doors
are not locked.
_
Passive arming mode starts the alarm control after the key is removed from the ignition key cylinder
and the doors are closed.
_
Detecting that the doors are unlocked does not set off the alarm during passive arming mode.
_
A forced door lock signal is not output during passive arming mode (see step 4).
_
When the theft deterrent system detects that the doors are opened during passive arming mode, the
alarm is not set off immediately because an entry delay time is set.
_
If any of the following conditions is met during passive arming mode, the theft deterrent system will
switch to active arming mode.
_
With all doors and engine hood closed, lock all doors by key operation.
_
With all doors and engine hood closed, lock all doors by wireless operation.
_
With any door or the engine hood open, close all doors and lock all doors and engine hood.
BODY ELECTRICAL - THEFT DETERRENT SYSTEM (Double Cab)
Author : Date :
4695